1、初拧扳手，可用必威西汉姆联官网g1线路也可用手动带响扳手。但无论用哪种扳手施工前都必须进行标定，以便控制初拧扭距值。手动扳手作为终拧工具时，必须每班进行标定，并做好标定记录。
1. For initial tightening, you can use electric spanner or manual spanner with ring. But no matter what kind of wrench is used, it must be calibrated before construction in order to control the initial torque value. When the manual wrench is used as the final tightening tool, it must be calibrated every shift, and the calibration record must be made.
2、终柠板手：扭剪型高强螺栓是一种自标量型螺栓，因此终拧只须把高强螺栓尾部螺栓头拧掉即可，扳手不用标定。
2. Final wrench: torsional shear high-strength bolt is a kind of self scalar bolt, so the final screw only needs to screw off the bolt head at the tail of the high-strength bolt, and the wrench does not need to be calibrated.
3、终拧紧固时应注意，待梅花头全部套入套筒后，才能按下必威西汉姆联官网g1线路开关，若内套筒只套入梅花头尺寸的1/3～1/2长度时按下必威西汉姆联官网g1线路开关，将会造成梅花头打滑，并且影响套筒的使用寿命。
3. It should be noted that the electric wrench switch can only be pressed after the ring head is fully inserted into the socket. If the inner socket is only inserted into the 1 / 3 ~ 1 / 2 length of the ring head, pressing the electric wrench switch will cause the ring head to slip and affect the service life of the socket.
4、紧固时，终拧必威西汉姆联官网g1线路应和构件摩擦面保持垂直，扳手倾斜是很容易导致螺栓尾部梅花头打滑，并易卡壳。
4. When tightening, the final tightening electric wrench should be vertical to the friction surface of the component. The inclination of the wrench is easy to cause the box head of the bolt tail slipping and easy to jam.
5、使用和保管中应注意防雨、防潮，发现有异常声音应立即停机检查。
5. Pay attention to rain proof and moisture-proof during use and storage, and stop the machine immediately for inspection in case of abnormal sound.
