Many users may not be unfamiliar with the operation precautions of the torsional shear type electric torque wrench, but for the users of the torsional shear type electric torque wrench who are new contacts, they may not understand the operation precautions of the torsional shear type electric torque wrench. In this case, if the operation is improper, it may cause damage to the torsional shear type electric torque wrench. The following users do not understand, We study together.

　　扭剪式电动力矩扳手使用注意事项

　　Precautions for the use of electric torque wrench

　　1. 接通电源前，应检查电源电压是否与货物铭牌相符，有无接地装置。当电源电压超过+10%时，应采取调压措施控制精度。地面好没什么区别。

　　1. Before connecting the power supply, check whether the power supply voltage is consistent with the cargo nameplate and whether there is grounding device. When the power supply voltage exceeds + 10%, voltage regulation measures shall be taken to control the accuracy. Good ground makes no difference.

　　2. 机器的操作条件为-10℃-40℃，过高或过低均会导致掌握精度下降。

　　2. The operating condition of the machine is - 10 ℃ - 40 ℃, too high or too low will lead to the decrease of the mastering accuracy.

　　4. 当机器用于装配螺母时，扭矩不应大于附加扭矩值。正常情况下，没有手柄拧紧或生锈的螺母，没有适合使用的手柄总成，以免形成机器保护。

　　4. When the machine is used to assemble nuts, the torque shall not be greater than the additional torque value. Under normal circumstances, there is no nut with handle tightened or rusted, and there is no handle assembly suitable for use, so as to avoid machine protection.

　　5、当改变转动位置时，电机必须停止转动后才能停止转动，严禁在运行中打开正反转开关。

　　5. When the rotating position is changed, the motor can only stop rotating after it stops rotating. It is strictly prohibited to turn on the forward and reverse switches during operation.

　　6、当手柄主动停止时可抓住开关等待4-5秒后手柄启动，否则手柄无法启动。

　　6. When the handle stops actively, hold the switch and wait for 4-5 seconds before the handle starts, otherwise the handle cannot start.